Stop Waiting for the Air to Heat Up: IR vs. Hot Air in Bio-Sensors If you’ve spent any time in bio-sensor fabrication, you know the drill with...

Why we stopped making “disposable” outdoor heaters Most outdoor heaters are basically sealed boxes. That’s a problem. After a few...

Stop Heating Your Equipment and Start Heating Your Wafers If you’ve ever worked with biosensor fabrication, you know the struggle with heat....

Why We Stress-Test Every Single Wafer Heater In the world of semiconductors, one tiny electrical leak is all it takes to scrap an entire batch of...

Why we’ve switched to IR curing for biosensors and chips When you’re building biosensors, the thermal part is always a bit of a headache....

Why we put our bathroom heaters through “torture tests” Let’s be honest: bathrooms are a nightmare for electronics. Between the thick...

The Truth About IP55 Ratings and Your Patio Heater You’ll see “IP55 rated” on almost every patio heater box these days. But here’s...

Your Bathroom Heater is Actually a Mold Fighter Most people think of those infrared lamps in the bathroom as just a way to keep from shivering while...

Keeping Your Biosensors Clean (And Your Sanity Intact) If you’ve ever worked in a Class 100 cleanroom, you know the drill. One tiny speck of...

Stop Fighting Your Bathroom Mirror: Getting the Heat Right There is nothing more annoying than stepping out of a relaxing shower only to be greeted...

Stop the Bathroom Mold Struggle with Infrared Most people look at an infrared lamp in the bathroom and just see a fancy heater. But if you look under...

Why Most Bathroom Heaters Die (and How We Stop It) Let’s be honest: bathrooms are a nightmare for electronics. You’ve got steam everywhere, constant...

Stop using light-bulbs to heat your bathroom Ever notice how those old-school “warmers” in bathrooms always seem to give up right when...

Keeping Your Bathroom Infrared Heaters from Becoming a Hazard Putting infrared lamps in a bathroom is basically a battle against steam. Water and...

Getting Semiconductor Drying Right (Without Wasting Power) When you’re working with wafers, you need the moisture gone—and you need it gone...